High frequency recommended vocabulary
ISO 16750-2 is the part of the environmental condition series that deals with the electrical loads to which automotive electrical and electronic equipment is subjected. It describes the conditions that arise on the vehicle electrical system during normal operation and during faults, and it defines a test for each of them so that a component can be qualified against the environment of its specific mounting position. The tests include the steady-state overvoltage that occurs when the alternator regulator fails, the superimposed alternating voltage produced by the rectifier, the voltage dip during engine cranking with its characteristic starting profile, the momentary drop when a load with a high inrush current is switched on, the inverse voltage transients produced by inductive loads, the load dump transient that follows the disconnection of a heavily loaded alternator, and the behaviour required when the supply is reversed or when a pin is short-circuited. Reference voltage curves and the applicable severity depend on the vehicle system voltage.
The AWG 100X Arbitrary Waveform Generator complies with ISO 16750, ISO 7637-2 and certain automotive manufacturer standards.
Load dump pulses generated by the LDS 200NxxD comply with ISO 7637-2, ISO 16750-2, SAE J1113 and numerous vehicle manufacturer standards
The GOS 05C100 ground offset simulator complies with ISO 16750-2, ISO 21780, VW 80000, GMW 3172.
The VOS 16C03 Voltage Offset Simulator is designed strictly in accordance with the Pulse 10a/10b/10c/10d specified in Table 31 of CHANGAN standard VS-00.35-L-10008:2018. The product integrates a high-performance signal generator with frequency up to 300 kHz and its voltage slew rate up to 80 V/μs.
The GOS 10C05 is a standalone test equipment used to simulate ground offset and power supply offset of multi-channel power supply circuits.
The GOS 05C200 is a standalone test equipment used to simulate ground offset and power supply offset of multi-channel power supply circuits.
• Using the product inquiry function can help you quickly learn about the product's price and other related information.
• You can either inquire about a single product directly, or select multiple products to add to the inquiry bar and inquire about them together.
• How to make an inquiry
1. Using the product comparison function can help you find the target product you need for selection more quickly and easily.
2. You can add up to 5 products for comparison. Product models and parameters may vary across different series. It is recommended to compare products within the same series.
3. How to use the comparison bar.
Phone: +86-512-68413700
Email: info@3ctest.cn
Address：No.99 E'meishan Rd, SND, Suzhou, Jiangsu, 215153, China，Suzhou, Jiangsu, 215153, China
© 2025 Suzhou 3CTEST
Leave a Message
